D4, D3, D2, and D Moulded Hose End

12 Foot Standard Hose Assembly, D4, D3, D2

Almost double the length of the standard 7 foot hose that comes with the Rainbow system. Very handy for reaching your ceiling fan without holding the unit and also nice for stairs so you can keep the Rainbow at the top or bottom of steps.

You can either use your existing R2807 Curved Wand or purchase and extra for use with this hose.

Standard Hose Assembly

Genuine OEM factory original 7 foot 18 yarn hose that fits the D4C SE (Special Edition), D4C, D3C, D3A, D2A, D2, and D model Rainbow system. Also was the standard hose for the R-2800C, R-1650C, R-1650A, and R1024 power nozzle.

This hose DOES NOT include the first stage chrome wand. Be sure to remove your curved wand and install into this new hose.

Even though it can be difficult, your old wand does remove from your standard hose. Use a hair dryer to heat up the rubber end of the hose to help remove with a twist and pull method.

Discontinued item numbers include:

• R1777 (D3/D2/R-1650/R1024)
• R2786 (D4/R-2800)
• R4717 9 Yarn (SE)
• R4716 9 Yarn (Hose w/ Molded Tip) (SE)

30 Foot Standard Hose Assembly, D4, D3, D2

If you hate to move the Rainbow, then this hose is for you.

You should be able to reach everywhere with this. If you don't have carpet and have a lot of bare floors, you can use this as your everyday hose.

This standard non-electric hose fits the D4C, D3C, D3A, D2A, D2, and D model Rainbow systems. This hose DOES NOT have electric connections and will not work with the power nozzle. It is for use with the standard attachments and wet pickup.

Rexair has tested and shown only a 10% loss of airflow compared to the standard 8 foot hose.