Rainbow Vacuum Power Nozzle PN-2 (PE) Complete Assembly - Page 3

Upright lock clip for the early PN-2E and PN-2 power nozzle. If the wand does not stay upright any longer, this could be the fix.

Do not bother purchasing this item, use the image to convert your existing air barrier to fit the new design R8201 manifold. Better yet, just purchase the new R6934 air barrier when replacing your manifold on the model PN-2 power nozzle.

Air barrier to fit over top the center belt power nozzle motor. Fits power nozzle model PN2.

Air barrier to fit over top the center belt power nozzle motor for the late version design.

Brush strip for the R6059 sole plate that fits the PN-2 power nozzle.

This gasket helps prevent air leaks which will reduce your machine's performance. This part can deteriorate and should be inspected during service.

Manifold gasket for the R8201 and R12900 manifold. The R8201 manifold fit versions 1, 2, and 3 of the PN-2E power nozzle and also the PN-2 power nozzle. The R12900 manifold fit the version 5 PN-2E power nozzle.

Gasket for the pivot arm that fit the PN-2E and PN-2 model power nozzle.

Plastic strain relief support that fits the E-2 (e SERIES™), D4C SE (Special Edition), and D4C Rainbow. Also is used in the PN-2E and PN-2 power nozzle.

Clevis pin for the pivot arm on the Rainbow model PN-2E and PN-2 power nozzle.

This kit includes two beater strips, two brush strips and two thread guards for the center belt driven brush roll that fits models PN-2E and PN-2. The two beater strips help apply more vibration to help clean heavier sand deep in the...

This kit includes four brush strips and two thread guards for the center belt driven brush roll that fits models PN-2E and PN-2.