R-4375 Power Nozzle Handle Receptacle

Electric Hose / Handle Assembly

Standard factory original OEM 8 foot electric hose that fits the following models:

PN-2 / R-4375C / R-2800C* / R-1650C*

*Cord length should be cut down to 43 inches for proper configuration on R-2800C and R-1650C models.

This hose is the second version and has a trigger in the handle to power on/off the brush roll assembly. Allows you to stop the brush roll from turning and go onto bare floors.

Call our technical support team if you have questions on using this with your R-2800C and R-1650C power nozzle. Very easy upgrade and well worth it.

The original part number for the R-4375C power nozzle was R4147. This item is a direct factory replacement.

PN-2 Power Nozzle Electric Hose Handle Kit

Handle kit for the PN-2 and R-4375C power nozzle electric hose. Works with the R5975 actuator switch that came standard on the PN-2 system.

This new handle kit design now uses (7) H566 screws. Older handle kits only used (6). Be sure to confirm and order an extra screw if needed.

When replacing the handle kit on the R-4375C electric hose, you can apply the included insert that covers the section that would allow the use of a switch actuator.

Old item numbers stamped inside handle include, R5759, R5760, R8140, R8141. R4294 is the item number to the warning label on the side.