E2 Type 12 120 and 240 Volt Rainbow Motor

E2 Type 12 Electric Cord / Harness Assembly

Factory OEM electric cord and harness assembly for the two speed E2 Type 12 (e2 Black, Silver, Gold) Rainbow vacuum.

Use a very small flat screwdriver to remove the interlock switch harness from the main power switch harness. Insert flat blade into the small hole in harness to "release" and flatten the clip that holds it into place.

Another option is to purchase the R12145 harness and we will combine with electric cord to allow for a full "Plug and Play" application. No need to do the above step.

In June 2016, the strain relief was increased to help prevent a short.

• New Design - 2.58 Inches (2 19/32, 65.69 mm)
• Original Design - 2.01 Inches (2 1/64, 51.12 mm)

Main Power Switch, E2 Type 12 (Black, Silver, Gold Series)

Main power switch for the two speed E2 Type 12 (Black, Silver, e2 Gold Series) Rainbow vacuum.

The quality of this switch was very poor for a certain time frame and could be the cause of your issue if your unit will not turn on.

*NOTE: DOES NOT fit the E-2 single speed model. Flip Rainbow over and confirm model on bottom of main unit.

Rainbow Model E2 Type 12 Separator

Original OEM factory separator for the two speed E2 Type 12 (Black, Silver, e2 Gold) Rainbow vacuum.

This part is very important to the working of the system. It separates the air from the water. It throws the water back into the water pan and allows the air to go up through the motor and out the exhaust.