E-2 (e SERIES™) Cap and Cover Assembly

E-2 (e SERIES™) Cap Cover Assembly

Main cap cover assembly for the single speed model E-2 (e SERIES™) Rainbow. Easily replace by removing the clear lens on each side of the cap cover assembly and then removing the four to six screws that hold it to the main housing.

Obsolete item numbers include R10222, R8289, R7300, R7299 (Applies to center section under handle).

This revised item replaces the original R8289 and R7211 upper noise baffle design from the early first version E-2.

e SERIES™ Raindrop Applique

Front applique decal that fits the cap assembly on the original E-2 (e SERIES™) Rainbow.

e SERIES™ Handle Applique

Top handle applique for the single speed E-2 (e SERIES™) version Rainbow. Easy double side tape installation.

Switch Actuator, E

Main power switch cover for the model E-2 (e SERIES™) Rainbow.

This item from serial number 9000000 through 9293949 had three ribs underneath and required the use of item number R8076 switch actuator gasket.

Effective serial number 9293950 and with a start date of June 12th 2000, this item was modified for use with switches without the gasket. The modified actuator now has two ribs and can be used with all E-2 (e SERIES™) switches. Just remove the gasket if your unit has one for use with this revised item.

E-2 (e SERIES™) Rainbow Top Motor Gasket

The top motor gasket for the single speed E-2 (e SERIES™) Rainbow fits in the top cap assembly and sits on top of the motor to create a seal to help improve performance.

Switch, w/o Gasket, E

Main power switch with out gasket for the later version E-2 (e SERIES™) Rainbow system.

Effective June 12th 2000 with a serial number 9293950.

E-2 (e SERIES™) Cap Assembly

Cap assembly for the Rainbow E-2 (e SERIES™) main unit. Comes with the R3765 power switch, R7213 top motor gasket, and the R10515 front cap applique.

Obsolete part numbers include R9711 and R7229 that may be found stamped inside by the switch.

If you are keeping your cap cover assembly and your original switch has a gasket on it, you will need to add the R8076 switch gasket to this purchase.

Also if you replace this item and you have the R7211 upper noise baffle, you will either need to transfer over the R7211 to this item or upgrade the cap cover assembly to the R10400 design.

E2 Type 12 and E-2 (e SERIES™) Version Two Handle Pad

Handle pad that works with the R10528 lock strip to attach to the cap cover. This installation is not the most easy and caution needs to be taken when installing with the lock strip to prevent breaking of the end tabs.

Effective serial number 9218342.

E2 Type 12 and E-2 Handle Pad Lock Strip

This lock strip holds the R10529 handle pad to the cap cover. This part requires a tedious and difficult installation and care needs to be taken to not break the end tabs.

Effective serial number 9218342.

e SERIES™ Version Two Front Cap Applique

Front cap applique that is made from the same material as the top handle applique. The previous version was made a metallic material.

Effective serial number 9198974 with a start date of February 10th 2000.

e SERIES™ Bezel Cover

Screw in bezel cover that installs over the center slot on top of the cap cover. For use on international E-2 (e SERIES™) Rainbow vacuums that are converted over to 120v systems.