Washer, R1024

R1024 Bearing Assembly

Original OEM factory bearing for the brush roll assembly on the R1024 power nozzle. Vibration or squealing noises could be coming from this part.

The early version bearings were plastic. This revised metal version holds up better to heat.

This part should operate at around 130 degrees fahrenheit.

R1024 A through D Power Nozzle Brush Roll

Distribulator / brush roll assembly for the R1024A, R1024B, R1024C, and R1024D power nozzle. This brush roll does not have a metal keeper or felt seal pressed into the wood on the end under the bearing.

*NOTE - The "D" version did have a metal keeper and felt seal but is no longer available. This brush roll is a direct replacement and has the correct size pulley for that version.

Pulley dimensions:

• 1^_21/64
• 33.59 millimeter
• 1.3225 Inches

This smaller pulley is needed to fit the original sole plate that does not have a relief stamped to accept the larger pulley. The larger 1^_5/8 pulley was introduced on the "E" version and allowed for more torque from the motor.

R1024 E through H Power Nozzle Brush Roll

Complete factory OEM brush roll assembly for the R1024 power nozzle version E through H. Make sure you confirm what version R1024 you have. This brush roll has the metal keeper and felt seal. The brush roll for the A and B versions do not.

If you have the original "E" version, you will see that the end pulley is on a completely threaded shaft. This design has been discontinued and the current design is a direct OEM replacement.

If you have a "D" version of the R1024, you will need to purchase an R1368 brush roll as it comes with the smaller diameter pulley that is needed to work with the non-relief sole plate than was standard equipment on this version.