Rainbow Vacuum AquaMate II Model AM-2 Pump Assembly Parts

The water inlet tube that includes the grommet, fits on the AquaMate II pump and goes down into the tank to extract the water. If you water is hard or has many sediments in it, then this part can possibly be clogged.

Check valve assembly that connects to the water inlet tube. This sits in the water in the supply tank and helps filter any larger sediments from getting into the pump.

Fill cap for the AquaMate II tank. This cap can also be used on the solution bottle to store any unused shampoo.

Water tank for the AquaMate II. This tank comes with no other parts or items attached.

Upper pump housing for the AquaMate II tank. With any repair that you will be doing inside the pump housing, you will need to replace this as you need to break it to disassemble.

Effective serial number 5150935, a second locking system was incorporated into the pump housing. The upper pump housing improvement now has both a snap together design as well as a screw together design. The screw together design was developed in case a pump repair was performed, it would not require the need to purchase the upper housing.

Water pump for the AquaMate II tank. This pump has been improved as the original pump would clog very easily from sediments or hard water.

A good rule is to run hot clean water through the wash cycle to flush all soap out of the pump. Then you should run the pump for a few seconds without any hoses attached and allow it to spit out all water from the pump. Do this before storing to increase the chances of a smooth use the next time you are ready to shampoo.

Pump grommet for the AquaMate II tank. This grommet is used inside the pump housing to keep supply hoses from getting damaged by movement.

Tubing clamp for the AquaMate II. This clamp is used in several place in the handle as well as in the pump housing area.

Quick disconnect tubing assembly that is connected to the pump inside the pump housing. This is the male version to the double female quick disconnect. This is the new design and became effective serial number 4913610.

Duckbill valve for the AquaMate II tank. This valve can get glued shut if clean hot water is not run through it to clear out any soap before storage.

Power cord for the AquaMate II tank. You will need to remove the upper and lower pump housing in order to be able to replace this power cord.

Lower pump housing for the AquaMate II tank.

Effective serial number 5150935, this pump housing was improved with added notches and room to prevent pinching of the pump hoses and supply lines.

This improved housing also has (4) drill markings to allow the use of H571 screws with the new design upper pump housing for assembly. Allows for easy removal in case of further repair.