Screw, Separator, D3/D2

Rainbow D4, D3, D2, or D Separator

This item fits model D4C, D3C, D3A, D2A, D2, and D. On the model D4C and D3C, you must have the original R1976 spider that came standard for this to fit correctly.

On March 28th 2002, Rexair discontinued production on this item and also the matching R1976 spider. We realize that many people still have the model D4C and D3C Rainbow system, so we offer used as a solution.

If you need to replace both separator and spider, then you would order item numbers R4100, R4101, and H555. These three items are a direct replacement and also an improvement.

The separator separates the air from the water. The water is thrown back into the water pan and it allows clean air to go up through the motor and out the exhaust. Be sure to take off and clean periodically as it can become clogged with dirt and will reduce your performance.

If you have a plastic separator that does not have a metal band around the outside edge, at some point the separator may break into pieces during use. The metal band was added to prevent this issue from occurring.

Screw, Separator, D2

Replacement screw (bolt) for the model D3A and D2 Rainbow and is designed to match the plastic separator that has a beveled edge around the center hole. This bolt under the head is chamfered to sit in this beveled pocket.

Works with the female type armatures found on the above original motors. If your motor has male threads on the end of the armature, then this is NOT the correct part. You need to order an H524 or an H555 separator nut.

Screw, Separator, D

Replacement screw (bolt) for the older model D Rainbow that works with the metal separator.

Works with the female type armatures found on the above original motor. If your motor has male threads on the end of the armature, then this is NOT the correct part. You need to order an H524 or an H555 separator nut.