This category covers the complete D3C motor assembly that includes the bearings, armature, separator, flange, and carbon brushes.
Effective serial number 4607000 with a start date of June 5th 1982 through serial number 5999999 and an end date of April 1986.
*Note: From serial number 4440000 (rough estimate) through serial number 454550, the "D3A" R1767 motor was standard. From 4545551 through 4607200, the revised R1909 armature and R2424 field was used.
-
BEST SELLER!Screw, #8-32 x .48 Inch, Bearing Shield, D3/D2Item #: H308This screw holds the slinger ring and bearing shield into the motor housing when the old ones rust or become corroded. For use with the D2 model.Price: $0.46 USD
-
Gasket, Cover Plate, D3/D2Item #:R1470Cover plate gasket for the R2104 version motor that was in the D3C, D3A, and late D2A model Rainbow.Price: $1.11 USD
-
Retaining Ring, D4/D3Item #:H523Retaining ring for the D4C R3242 motor and D3C R2104 motor design. This is a good item to replace as many times this part gets sprung and does not hold tight onto the armature shaft. You will need snap ring pliers to install and...Price: $1.30 USD
-
Screw, #8-32 x .31 Inch, Bearing Plate, D3/D2Item #:H475This pan head screw is used to hold the bearing plate to the motor housing on all D3 and D2 model Rainbow Vacuums.Price: $0.36 USD
-
Screw, #8-32 x .50 Inch, Brush Holder, D3/D2Item #:H309Use this replacement screw to hold the carbon brush holder into the motor housing in your D2 or D3 model. A total of 4 are required.Price: $0.20 USD
-
Screw, Field, D3/D2Item #:H535Original field screw for the model D3C, D3A, and D2A version Rainbow. Course thread for contact with the R1449 Insulator-Field Screw Insert.Price: $0.50 USD
-
Screw, #8-32 x .38 Inch, Ground, D3/D2Item #:H25Always ground the power cord and receptacle on the D3 and D2 Rainbow to the motor and / or main housing.Price: $0.65 USD
-
Shroud, Motor Housing, D3/D2Item #:R1407Plastic shell that installs over the motor housing on the by-pass motor design. Airflow goes between this item and the motor housing and is what directs the air outside the motor housing and is why this design is called a by-pass...Price: $5.13 USD
-
Shield, Bearing, D3Item #:R1980The bearing shield helps protect the lower bearing from rust and corrosion. Replace this part if you spot any deterioration in the shield.Price: $1.56 USD
-
Slinger Ring, D4/D3Item #:R1979This part is a common replacement part due to the high change of rust and low cost of replacement.Price: $9.46 USD
-
Spacer, Lower, D3Item #:R1982Lower spacer for the R2104 motor in the model D3C Rainbow vacuum. This item is the first part you would install when assembling the fans. It is slightly thicker than the top spacer.Price: $2.57 USD
-
Spacer, Middle, D3Item #:R1983Middle spacer for the R2104 motor in the model D3C Rainbow vacuum. This spacer looks like an hourglass.Price: $2.66 USD